• Inspect Control Unit condition and clean.
• Check indications and change bulbs as necessary.
• Simulate fire, fault conditions & check operation.
• Check charger output, adjust as necessary.
• Check battery condition and clean.
• Inspect System components and cabling, joints and terminations (where visible).
• Test all detectors on each zone and check for correct operation.
• If site conditions permit, check sounder circuit output and general audibility. Check audibility of one sounder in rotation.
• Remove all detectors and clean. Recalibrate where applicable. Replace and test.
• Check all break glasses. Replace if necessary. Check operation.

HOSEREELS

• Visual inspection of system all joints and fittings (where accessible) for leakage. Check corrosion levels and paintwork.
• If site conditions permit, exercise isolating valve and auto valve (if fitted) and flush out Hose. Drain and rewind. Check for unit leakage. All Hose Units to be serviced each visit.
• Check Hose guides and rollers.
• Clean and check hosereel cabinets. Lubricate the hinges.
• Inspect the swing mechanism of each hosereel unit and lubricate where necessary. Run out hose, check for damage or deterioration. Check nozzle mechanism.

FIRE PUMP

• Visual inspection of Pump Room pipe work, joints and fittings for leakage. Check corrosion levels and paintwork
• Exercise Electric Pump, check start sequence, check Star/Delta functions.
• Exercise Diesel Pump, check start sequence, oil pressure and temperature (where fitted), engine speed (where fitted), shutdown mechanism. Check batter(s) and charger. Check fuel level.
• Annually change oil and filters, controller fuses, check pump alignment and coupling condition.
• Check pump motor set, mountings, bearings and leakage.
• Check pressure switch operation, settings, flow switches, pump run timers, system standing pressure and fall-back.
• Check and exercise all valves.
• Check condition of tank, water levels and level switches (if fitted).
• Lubricate moving parts as necessary.
• Check weight.
• Inspect Pressure Gauge (if fitted.)
• support brackets.

DRY RISER / WET RISER

• Check and exercise landing Valves (where possible).
• Check Breaching Inlet and Drain Valve.
• Inspect condition of Hoses (if fitted).
• Lubricate moving parts.
• Annually pressure test the pipes.

FOAM SYSTEM

• Clean and check condition of valves.
• Check operation of valves.
• Check pump operations.
• Check Linear Heat Sensor operation.
• Check condition of nozzles, pipe work & supports, repair or replace where necessary.
• Check Sounder / Flash lamps.
• Check control panel operation.
• Check Battery condition.
• If site conditions allow check the flow with water only.
• After flow test drain out and clean all Nozzle pipelines.
• Foam circulation.
• Sampling and testing of foam.
• Top up of foam – (free supply from client.)

CARBON DIOXIDE SYSTEM

• Clean and check all Heat Detectors.
• Clean and check Sirens.
• Clean, check Lamp and Manual Release units.
• Check Cylinder Valves / Selection Valves.
• Check Alarm panel. Release Control Panel Operations.
• Check Shutter Door release mechanism.
• Check all power Supply units and batteries.
• Check Repeat Signal to main Fire Alarm Control Panel.

EMERGENCY LIGHTS

• Clean and check for the proper functioning of each emergency light (and programme if necessary).
• Check the battery(s) and battery chargers.
• Replace bulbs / tubes if found defective.

FIRE DOORS

• Check for proper functioning of fire doors.
• Lubricate hinges of fire doors.

Monthly Inspection

• Check fire alarm panel condition and test few signals.
• Check battery condition and charging levels.
• Visually inspect complete system, confirm all in normal condition.
• Check fire pump condition and test.
• Check fuel and oil levels in diesel engine.
• Check all fire extinguishers.

<<Back to FM